Journal article
Options for the Mechanized Processing of Hardwood Trees in Mediterranean Forests
International Journal of Forest Engineering, Vol.20(1), pp.39-44
2009
Abstract
In this study, three different processing options for trees yarded whole at the roadside in a beech thinning operation, typical of the Italian Apennine mountain, were studied. Trees were delimbed, crosscut, and stacked, respectively, by a four- man crew equipped with chainsaws and a hydraulic loader (motor-manual control thesis), by a small stroke harvester head mounted on a light excavator, and by a dedicated 6-wheel harvester. Under the conditions of the study, mechanized processing was less expensive than the motor-manual control thesis, regardless of the specific option. Cost reductions amounted to 27 percent and 38 percent, respectively, for the light processor and the heavy harvester. Annual usage is a crucial factor for the introduction of industrial mechanization: the heavy harvester is preferable to motor-manual processing only when the annual output exceeds 5,000 metric tonnes (t) per year. When this figure grows above 13,000 tonnes per year, it will profitably replace the light processor, not just for monetary gain, but for the inability of the lighter unit to cope with such a heavy workload. On the other hand, the light processor was always less expensive than the motor-manual control, while requiring an additional investment of only (US)$47,000. Therefore, the acquisition of a light processor represents the most viable option, at least for immediate deployment. Its productivity closely matches that of the yarder, allowing for hot-deck (synchronic) operation. All of the options can efficiently process beech trees within the full range of diameters normally obtained from thinning operations, and up to a 30 cm diameter at breast height. As expected, productivity increases with tree size, and even more so for the mechanical units, which normally handle just one or a few trees at a time. Under the conditions of this study, both mechanized options have a potential for bringing processing cost near (US)$10 per tonne, which is half the cost of traditional motor- manual processing.
Details
- Title
- Options for the Mechanized Processing of Hardwood Trees in Mediterranean Forests
- Authors
- Raffaele Spinelli (Author) - CNR IVALSA, ItalyNatascia Magagnotti (Author) - CNR IVALSA, ItalyCarla Nati (Author) - CNR IVALSA, Italy
- Publication details
- International Journal of Forest Engineering, Vol.20(1), pp.39-44
- Publisher
- Taylor & Francis Inc.
- Date published
- 2009
- DOI
- 10.1080/14942119.2009.10702574
- ISSN
- 1494-2119; 1494-2119
- Organisation Unit
- University of the Sunshine Coast, Queensland; Forest Industries Research Centre; Forest Research Institute
- Language
- English
- Record Identifier
- 99448906802621
- Output Type
- Journal article
Metrics
480 Record Views